Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
General Description
This power unit is made solely for that smaller lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has been extensively employed from the marketplace of logistic products for instance minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve with all the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This energy unit is built solely for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as the velocity managed from the adjustable needle valve. When the lift rises to a large positoin, however the electrical power supply is cut, the reducing motion is controlled by the manual override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This power unit is developed solely to the big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve along with the pace managed by a pressure compensated flow control valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This electrical power unit is made solely to the large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the pace controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is reduce, the lowering motion is controlled through the guide override function.
Particular Notes
one. This power unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic parts concerned before installation of the energy unit.
3. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
4. Oil shifting is needed following the preliminary one hundred operation hrs,afterwards once just about every 3000 hrs.
five. The power unit shown is intended to be mounted vertically.